Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

AutoQoS Error

Hello All,

I am trying to apply auto qos on my 2821 router. We are running PPP encap and when i try to enable the auto qos voip trust command, i get the following message "AutoQoS Error: the following command was not properly applied: service-policy output AutoQoS-Policy-Trust" Also, and I can only assume this is related, my class map and policy map configuration disappear from the running config file.

1 REPLY

Re: AutoQoS Error

There are few things you need before enabling autoqos:

- CEF enabled

- interface not in shutdown state

- IP address have to be assigned to interface

- bandwidth configured helps a lot

Check this Q&A for more info: http://www.cisco.com/en/US/technologies/tk543/tk879/technologies_qas0900aecd8020a589.html

rate if this help

753
Views
0
Helpful
1
Replies
CreatePlease to create content