Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Aware of Gatekeeper address lookup failures

How can I know when a Gatekeeper send an resolution failure to gateway.

thanks

2 REPLIES
VIP Purple

Re: Aware of Gatekeeper address lookup failures

You can use the following commands on the gatekeeper:

term mon

debug h225 asn1

debug gatekeeper main 10

These will show you the messages sent between the gateway and gatekeeper as well as the gatekeeper logic for accepting or rejecting the call. Be sure to do "undebug all" when you're finished.

Hope this helps. If so, please rate the post.

Brandon

Community Member

Re: Aware of Gatekeeper address lookup failures

Hi Brandon,

I'm thinking in management not in troubleshooting. I already search for SNMP counter or show command (the 'sh gatek perform stat' doesn't show the address lookup failure). The gtk has more or less 6000 prefix and alot of activity, and for this reason it's impossible to look for debugs.

Thanks anyway.

regards

149
Views
4
Helpful
2
Replies
CreatePlease to create content