How would one convert a layer-2 port's "switchport rate-limit" bandwidth statement, on a 6509 -w- WS-X6748-SFP ports, to a routed/layer-3 "wrr-queue" bandwidth statement policy? Basically trying to hard-core the port's speed to 20MB. Current/tested layer-2 port bandwidth setting:
rate-limit input 20000000 5000 5000 conform-action transmit exceed-action drop
rate-limit output 20000000 5000 5000 conform-action transmit exceed-action drop
Got lost in how to use/configure all WRR's four queues... just need to limit the port's bandwidth to 20MB. Any suggestions would be appreciated.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...