Brooktrout Technology TR114+P4L PCI Analog Voice-and-Fax Card
I have a customer with RightFax 9.X using the above mentioned card. I have the gateway configured with 12FXS ports using H323.
When the call gets to the RightFax Server it sometimes has 2 digits as the DID and others 3 but never 4. It needs to be 4 so that it matches up with the configured users so it knows how to route the faxes. Since it does not it dumps them into a default routing bucket.
CCM 4.3(1) using 2821 with 3 PRI and 12FXS with 12.4(11)T.
When I debug from the gateway I see that I am passing the information in the dial-peers to the port 0/3/0 but Brooktrout sees only 2-3. The number is 5490 but BT sees it as 54 or even 549 but never 5490.
It is running H323 and also MGCP. The PRI's are controlled by MGCP and the FXS ports are just H323. I am testing to see if I can get it to work under H323 and if I can I will switch the entire GW to H323.
Has anyone experience with this issue or Brooktrout settings.
If it comes down to it I will open a TAC case but thought I would ask the forum first.
Re: Brooktrout Technology TR114+P4L PCI Analog Voice-and-Fax Car
The problem may be very well be with the fax card that could not be waiting long enough for all the digits, or something similar. The router is probably playing out the digits correctly, you have this confirmed by usin a DTMF decoder on the line, these are commercially available.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...