I have been given a task to verify BTS and PackeCable Compatibility.
This is the first time I have ever heard about PacketCable.
Did some search on cisco.com and came to know that its used for provisioning [broadly speaking].
My task is to figure out if BTS 10200 is PacketCable 1.0 and PacketCable 1.5 compatible. I found that its PacketCable 1.0 compatible and another document depecting the limitation on CMS Subscriber Provisioning "The scope of the feature is limited to subscriber provisioning in a PacketCable 1.5 network"
If at all BTS is compatible with PacketCable 1.0/1.5 -
1) When the server is configured in the PacketCable 1.0 mode, will it service a PacketCable 1.5 compatible CPE device( MTA) ?
2) When the server is configured in the PacketCable 1.5 mode, will it service a PacketCable 1.0 Compatible CPE device( MTA) ?
Packetcable specifications cover many areas including provisioning, audio servers, signaling, pstn interconnect, event messaging, electronic surveillance, security, etc. The BTS supports both PC1.0, 1.5 and PCMM as defined here:
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...