We have configured a Cisco AS5350 for terminating originating traffic. This voice gateway is connected to 4 E1s which are E1 R2 CAS. I have configured preference on the dial-peers in such a way that the first E1 has 1st preference, second E1 has 2nd preference and so on. The issues that we are facing are these:
a] On our first E1 the DS0s Active High Water
Mark has never crossed more than 24 though we
have an E1s connected to the gateway. Also
when we see the call resource voice stats it
shows the Addressable Channels under DS0
Statistics as 120 [for 4 E1s].
b] If we have given the first preference to the
1st E1, second preference to the 2nd E1 and so
on then why are the calls going to the second
E1 even before the first E1 is getting filled
up i.e. why are the calls going to the second
E1 even before the active DS0s on the first E1
The Output of the E1 Call Counters are given below for analysis:
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...