i am having some trouble Setting up Valcom VIP402 Speakers as SIP Endpoints so IPCelerate can Page to them. I am setting them up as a SIP Endpoint using a Custom SIP Security Profile to allow Digest Credentials. they register to Call Manager but i am unable to dial their extensions. when i do, i get a busy signal. using valcom's utility, i can sucessfully send a test page... I figure there must be soemthing off in the config of the speaker itself but it could be CM...
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...