1. locate the voip dial-peer that leads to that specific customer
2. add the command "clid network 12345" under that dial-peer.
this way, every time this voip dial-peer is used to route the call to that customer, the caller ID displayed will be 12345 (which u can change "12345" to anything you want).
You can do the same thing under the Pots dial-peer too, if you want that caller ID of any call originating from the PSTN to be changed to 12345 at all customers location.this latter solution is more general, the former is specific and granular. and i have been able to accomplish this on 2600xm, but i think it will work on the AS class as well.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...