Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Caller name/ID on incoming MGCP Gateway

Where do you apply parameter setting changes to allow not only Caller number but name as well to come through on a MGCP VG? What parameters in CCM 4.1 should be checked? Isn't caller-ID needed on the dial-peer as well. Sprint is the carrier.

Thanks for any guidance

2 REPLIES
Cisco Employee

Re: Caller name/ID on incoming MGCP Gateway

What type of PSTN circuit is this?

If its an FXO port, caller-id is not supported in MGCP.

If its a PRI, how is calling name being delivered? Display IE or facility IE? A "debug isdn q931" for an inbound call will show you this.

New Member

Re: Caller name/ID on incoming MGCP Gateway

It is being delivered via: Display i = 'Voicemail' as taken out of q931 debug. So is there a parameter in CCM that needs to be set? or on the VG itself?

Thanks.!

248
Views
0
Helpful
2
Replies
CreatePlease login to create content