i have Cisco PGW200 and AS5300, where the GW is connected to PSTN over E1's and im using the 1st time slot for SS7 signaling, the customer at PSTN dials 0800 number to access the IVR, the call is running very smoothly, but the calling number for the call leg "PSTN to 0800" doesnt appear in isdn setup message :S
im responsible of the AS5300 GW only, i have asked the PGW team to provide me with the trace, and im writing down the output of the debug isdn on the GW, where the calling number field doesnt appear at all
*Feb 8 22:42:50.804: ISDN Dc3/2 SC Q921: User RX <- INFO sapi=0 tei=0, ns=76 nr=20
I like to participate because i have as this case but in other results.
1. Case description:
Calls are been dropped by my AS5400 when it receives calls without dialer ID.
Example when any dial number which is terminated by my AS5400 but when AS5400 sees no Calling ID the AS drops this callâ¦ do you have any idea to make my AS to pass all calls with or without ID number.
i have comments if you can answer them:
1. my customers will dial 55004444 to reach IVR or when they dial 55004444 IVR will active and forward them to other destinations â¦.ok.
I have this configuration are these correct or not?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...