I have some problems with UGCA. I have some access-servers that injected via calltracker some data into the UGCA software. After running the loadcdr_file.sh, I can see some calls (voice calls) but I cannot see the modem calls. I was verified in the syslog file and I can find all the registration injected by calltraker.
If anybody has some ideea conerning this problem, please let me know
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...