Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Can I use AS5350 for Sip to Sip gateway with transcoding

I have an issue where we need to transcode g711ulaw to g711alaw between voip providers using SIP

I would like to know if it is possible to use an AS5350 for such a task?

Any links or references to what I would need to do in the configuration would also be greatly appreciated.

2 REPLIES

Re: Can I use AS5350 for Sip to Sip gateway with transcoding

i am not sure if u have DSPs for this !

Cisco Employee

Re: Can I use AS5350 for Sip to Sip gateway with transcoding

Yes, this can be done by using AS5350 as CUBE.

Please go through the documentation:

Make sure below is configured with proper dial-peers.

voice service voip

allow-connections sip to sip

dial-peer voice 100 voip

incoming called-number 919.......

codec transparent

dial-peer voice 200 voip

destination-pattern 919........

codec g711alaw

Below is for your reference.

Cisco UBE on Cisco.com

http://www.cisco.com/go/cube

Cisco CommunicationsTransformations Whitepapers

http://www.cisco.com/go/cube(section of Whitepapers)

Customer Case Studies

http://www.cisco.com/go/cube

Cisco Networkers Presentations

SIP Trunks for PSTN

CUBE Designs

http://www.cisco.com/go/cube

Cisco UBE PBX Interoperability Reports (Avaya / Nortel)

http://www.cisco.com/en/US/solutions/ns340/ns414/ns728/networking_solutions_products_genericcontent0900aecd805bd13d.html

390
Views
0
Helpful
2
Replies