Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CAS to FXS on Cisco 2851

Hi,

When there is an incoming E1 R2 CAS call directed towards an FXS, the call does not complete. The cisco does collect the digits on the incoming side (CAS) but does not send it to the FXS. Is there any specific configuration that needs to be done for this?

Thanks

Ashwin

6 REPLIES
New Member

Re: CAS to FXS on Cisco 2851

The E1 R2 config is as below

controller E1 0/3/1

framing NO-CRC4

clock source line primary

ds0-group 12 timeslots 1-12 type r2-digital r2-compelled

cas-custom 12

country brazil

metering

release-guard-time 500

category 2

signal-end-to-end

answer-signal group-b 1

ani-digits min 7 max 11

Re: CAS to FXS on Cisco 2851

Hi Ashwin,

Can you try this:

voice-card 0

no local

New Member

Re: CAS to FXS on Cisco 2851

Thanks for the reply.

I tried that but there was no difference.

What I did now was to make

FXS->cas_loop_on_cisco_itself->FXS

All of this on the same box and I still see the problem.

Am atatching the logs for this.

Re: CAS to FXS on Cisco 2851

Well this doesn't look good:

2 22:37:20.302: [0/3/0:12(1), R2_Q421_IC_ANSWER, E_DSP_SIG_0000] -> ERROR: INVALID INPUT

Then it looks like a few seconds into the call 0/0/0 hangs up:

*Apr 2 22:37:26.894: htsp_process_event: [0/0/0, FXSLS_CONNECT, E_DSP_SIG_0100]fxsls_offhook_onhook, HF duration Max=1000, HF duration Min=150

-nick

New Member

Re: CAS to FXS on Cisco 2851

I dont know what this means

R2_Q421_IC_ANSWER, E_DSP_SIG_0000] -> ERROR: INVALID INPUT

The terminator never rings. Any options of what could be wrong and how we can go about this?

Re: CAS to FXS on Cisco 2851

Hi Ashwin,

I'll be honest - I don't have all of the E1 R2 states and ABCD bits memorized. I usually have to stare through lots of examples and documentation to figure out each state.

You may want to start here:

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_configuration_example09186a00800ad389.shtml

This page has some of the bit tables required:

http://www.quintum.com/support/xplatform/r2/index.shtml

Best of luck!

-nick

267
Views
0
Helpful
6
Replies