Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CEoIP with RTT less than 1 ms

Hi,

Got Issues with a unframed CEM setup between 2 PBX.

I'm not a PBX tech, however, my boys says that when they shut a B channel down on 1 side, the other side see nothing and it should.

Do I have to run "framed" mode CEM to get this to work ? In framed mode, Nortel PBX complaint with weird errors

2nd issues is:

I have also fews slips on the PRI incrementing.

My Clocking is setup like:

CO->PBX->ROUTER01-ROUTER02->PBX

In router 01 i'm setup this way:

clock source line primary

In router 02 i'm setup this way:

clock source adaptive 1 closed-loop

I have seend adjustment of the clock. Guys reported no slip for 30min.. however, not sure If I'm using the correct setup ???

2 REPLIES
New Member

Re: CEoIP with RTT less than 1 ms

I've got the similar setup. Option 81->3845 CEM->Network->2811 CEM->Option 11.

I had loss of frame errors when I was setup for unframmed. My config is below.

Host

controller T1 1/0

framing esf

cem-group 0 timeslots 1-24

cablelength short 110

description CEM

!

cem 1/0/0

dejitter-buffer 80

xconnect 10.255.255.1 0 encapsulation udp

local ip addr 10.255.255.20

local udp port 15901

remote udp port 15901

!

Remote

controller T1 1/0

framing esf

cem-group 0 timeslots 1-24

clock source adaptive 0 closed-loop

cablelength short 110

description CEM

!

!

cem 1/0/0

dejitter-buffer 80

xconnect 10.255.255.1 0 encapsulation udp

local ip addr 10.255.255.20

local udp port 15901

remote udp port 15901

!

New Member

Re: CEoIP with RTT less than 1 ms

Thanks, I still run unframed. however i've started data-protection mode, ceoip crc check.

its running clean for a week and half.

I've try framed configuration, and pbx guys, start seeing weird error in PBX. I just revert back. I'm not sure why.

289
Views
0
Helpful
2
Replies
CreatePlease login to create content