Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Change point to point into point to multi point

I'm new to the UC500 and don't know how to set the voice from point to point into point to multi point, i'm using KPN euro ISDN multi point ? can some one help me out?

6 REPLIES
Hall of Fame Super Gold

Re: Change point to point into point to multi point

By default, the ISDN BRI is set for multipoint. In this case is recommended that you use "isdn tei-negotiation preserve" under BRI interface.

If you want point-to-point, use "isdn static-tei 0".

Hope this helps, please rate post if it does!

Community Member

Re: Change point to point into point to multi point

Dear p.bevilacqua,

I do question that, i use a not multi isdn and than it's working when i do use the multi isdn it's not working.

Thanx andy

Hall of Fame Super Gold

Re: Change point to point into point to multi point

Which exact IOS are you using ?

Community Member

Re: Change point to point into point to multi point

I don't know at the moment. I'm not at the location where the UC500 is placed. Didn't set SSH open for i-net at the moment so can't login remote.

Why is there a trouble with older ones?

Hall of Fame Super Gold

Re: Change point to point into point to multi point

You need to run 12.4(11)XW5, previous ones are buggy.

Community Member

Re: Change point to point into point to multi point

Thanx for the info i'll try it tommorow

173
Views
0
Helpful
6
Replies
CreatePlease to create content