Hi, i have a cisco 3745 ISO 12.4(17a) with 2 VWIC-1MFT-G703 in slot 0 and NM-HDV2-2T1/E1 in slot 1. i can see the 2 G703 E1 controller but i can not setup the 2 E1 on the NM-HDV2-2T1/E1. on the sh diag i can see Slot 1:
Hi thanks for your answer, i keep the ATM as i will installed a 3rd E1 G703 in the Wic.
i think your highligt the issue, probably the guy who insert the PVDM did not insert in the right position or wrongly insert or even did not insert....(i work remotely so trust the guy who told me he have install); anyway the PVDM module is now shown in the sh diag. and the router is now working get incomming/outgoing call. thanks again.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...