Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Combining 2E1 Controllers to act as 1 for voice calls

Dear All,

I have a VWIC2-2MFT-T1/E1 card which is connected to a Siemens PBX using 2 E1 controllers (using Q-SIG). I also have enough PVDM2 modules to accomodate 60 voice channels.

I want to utilize both controllers on this card to get 60 voice channels. However, i would like to group both of these controllers somehow, to act as one. Basically i just want to increase the number of voice calls between the PBX and the router, but the routing of calls to thats PBX should consider both cpontrollers as one logical interface. Is there a command that can allow me to do that, something like trunk-group or pri-group.

Appreciate your help.

Regards,

Mouhannad El Hajj-Mahmoud

1 REPLY
Hall of Fame Super Gold

Re: Combining 2E1 Controllers to act as 1 for voice calls

Sure, trunk-groups

trunk group to-pbx

hunt-scheme least-used

interface x/y/0:15

trunk-group to-pbx

interface x/y/1:15

trunk-group to-pbx

dial-peer voice 100 pots

destination-pattern 3...

incoming called-number 4...

direct-inward-dial

trunkgroup to-pbx

Hope this helps, if so please rate post!

122
Views
10
Helpful
1
Replies