Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Configure BLF on SPA500s sidecar

Hi there,

So I'm trying to configure BLF on a Metaswitch VP3510 softswitch.

Currently I'm using the following config to program the line:

fnc=sd+blf+cp;sub=xxx@yyy.yyy.yyy.yyy;nme=xxx

xxx=extension

yyy=public IP of phone

The status of all the lines are currently a solid orange meaning the lines are not registered.

The lines are currently functioning as speed dial buttons but I cannot see the status of the line (in use / ready...etc).

I'm not sure if 'fnc=sd+blf+cp;sub=xxx@yyy.yyy.yyy.yyy;nme=xxx' is the right syntax. Not sure what nme is for or if I should be using something like 'usr' or 'ext' ..

I was wondering if anyone had advice on how to configure BLF on a Metaswitch system.

Any feedback would be greatly appreciated!

Many thanks,

-Jason

Everyone's tags (4)
1 REPLY
Hall of Fame Super Gold

Configure BLF on SPA500s sidecar

Wrong forum, post in "small business p ip phones". You can move your post using the actions panel on the right.

1018
Views
0
Helpful
1
Replies
CreatePlease to create content