We have a single 2610XM Router at central site and all remote 805 Routers.We want to configure ATA 186 at all the sites for VoIP connectivity.Can we configure the Gateway and Gatekeeper on the single 2610XM Router?It has come loaded with h.323 software feature set and has flash of 16MB and DRAM 32MB.
Yes you can run both Gatekeeper and Gateway functions on the 2610XM router at the same time. You may need to bump your DRAM up in order to run the latest images that support both Gatekeeper and Gateway functionality. For example you could use the following image (c2600-ix-mz.12.3-1a) which is the IP/H323 featureset in the 12.3 release train. The minimum memory requirement for this is 48Megs of DRAM.
Once you have your gatekeeper configured, you would then configure your ATA's to point to the gatekeeper, and all your remote ATA's will be able to locate and call each other. If your 2610XM is also utilized as the PSTN gateway, then your remote ATA's can call out to the PSTN via the same router.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...