Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Conflict in called numbers Conflict in called numbers ..... ???????? ....

Dears,

my company provide DIDs in range 63xxxxxx but this exactly same number for Phillipines Fix 63 in my CDR there is a conflict between Phillipines Fix 63 and my DIDs 63xxxxxx i need to Distinguishes between them i have my AS5400 and PGW2200 ... how can i do that?

translation-rule 2

Rule 2 ^5555#9626 6

Rule 6 ^06 6

Rule 7 ^07 7

translation-rule 1

Rule 7 ^06 6

Rule 8 ^07 7

Rule 10 ^5555#9627 7

!

=========================

dial-peer voice 1 pots

destination-pattern .T

progress_ind progress enable 8

progress_ind connect enable 8

translate-outgoing called 1

port 7/2:D

dial-peer voice 100 pots

incoming called-number 630000..

direct-inward-dial

forward-digits all

!

dial-peer voice 200 voip

destination-pattern 630000..

progress_ind setup enable 3

session protocol sipv2

session target ipv4:55.55.55.31

codec g711ulaw

fax-relay ecm disable

fax rate 14400

fax protocol t38 ls-redundancy 0 hs-redundancy 0 fallback none

any help please?

1 REPLY
Silver

Re: Conflict in called numbers Conflict in called numbers .....

If you have a Cisco IOS Software gateway, a translation rule can be created and applied to the outbound Voice over IP (VoIP) dial peer. The following is an example configuration:

translation-rule 1

rule 1 ^0760 7300

dial-peer voice 10 voip

translate-outgoing called 1

Telephony Signaling Configuration Examples and TechNotes

http://www.cisco.com/en/US/tech/tk652/tk653/tech_configuration_examples_list.html

145
Views
0
Helpful
1
Replies
CreatePlease to create content