First off I am new to VOIP...so with that, I just installed CUCM 7 (old I know, but it's for my home lab). I was wondering how I intergrate it into my existing network. I've been google'ing and searching for weeks now, and I can't seem to figure it out.
Do I make that CUCM 7 server the gateway, or leave that on the router? and then how do I get my phones to register on the CUCM and not my router?
Thanks for any advice/help. Configuration examples help a lot.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...