I'm trying to define and use a custom cptone. But no matter what I do I can't seem to get it to take effect.
For testing I'm basically trying to set every possible tone to the equivalent of a dial tone.
As far as naming the custom cptone when I'm in the voice port itself it only allows me to use the predefined names including Custom1 and Custom2. So I tried to create those below but I don't think it is actually using them.
What am I doing wrong? A partial config is below. This is a 2600xm IOS 12.4(7)
Getting the 2600 to play dial tone instead of fast bust after the remote site hangs up would really help clear the ports quicker as they are into a voice mail system that is looking for dial tone disconnect. As it is now it takes anywhere from about 30 seconds to a minute or so for the ports to clear on the router (waiting in FXS_PARK state till voice mail times out) which is causing problems if a new connection is attempted from the remote end to a parked port.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...