Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Debugging fax relay t30 level-1 all

Cisco 2811 equipment

What is the information, of debug fax relay t30, that permit to understand the senquece of the T30 deb messages, in case of there are more the one transnission fax simultaneously like for the attched tarces?

2 REPLIES
Anonymous
N/A

Re: Debugging fax relay t30 level-1 all

The incoming or outgoing numbers must be a valid E.164 destination. The period symbol (.) as a wildcard should not be used. Instead of a wildcard, leave the space blank to indicate that any numbers can be valid. There are no limits to the number of debug entries. The number entered generates a match if the calling or called number matches up to the final number of the debug entry. For example, the 408555 entry would match 408555, 4085551, 4085551212, or any other number starting with 408555

New Member

Re: Debugging fax relay t30 level-1 all

sorry. probably I don't explain well my question.

My problem isn't how to enable T30 deb, but hw to sort the message trace of a T30 deb in case of there are more then one TX fax on the same period. Into the preview attach there are 3 TX fax on the same time and I can't understand the message sequence of each FAX call.

Thanks

243
Views
0
Helpful
2
Replies