Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

dial-peer voip session target ras remove secondary dialtone

i have a pri circuit that contains the number NNX-XXX-7599.

i configured the pri , dial-peers.

the 7599 number is my meeting place 8106 server, registered to gatekeeper on the same router (3745) as the pri.

i am getting secondary dialtone.

when i dial the number from the co i get dial tone and have to enter hte last 4 digits again then the call connects

a cisco white paper says to add direct-inward-dial. this command is not available with dial-peer voice voip.

how can i get this number to connect directly through.

thanks for any help

Jeff

dial-peer voice 7599 voip

destination-pattern 7599

session target ras

dtmf-relay h245-alphanumeric

codec g711ulaw

ip qos dscp cs5 media

ip qos dscp cs3 signaling

controller T1 2/0

framing esf

linecode b8zs

pri-group timeslots 1-24

description SBC BL PRI2 H.323

interface Serial2/0:23

no ip address

no logging event link-status

isdn switch-type primary-ni

isdn incoming-voice voice

no cdp enable

4 REPLIES
New Member

Re: dial-peer voip session target ras remove secondary dialtone

Can you post your full confgiuration

New Member

Re: dial-peer voip session target ras remove secondary dialtone

HI

I have a combination of MGCP and H.323 trunks

the trunk i am working with is 2/0

here is the config

thanks for any ideas

attached is the config

New Member

Re: dial-peer voip session target ras remove secondary dialtone

Hi

You need to add a "POTS" dial-peer for the 2/0:23 Voice port matching somthing like this

dial-peer voice 455 pots

incoming called-num 7599 ! for example

direct-inward-direct

port 2/0:23

New Member

Re: dial-peer voip session target ras remove secondary dialtone

Not sure that will work.

the 7599 number is coming in on 2/0:23 and needs to point to RAS the gatekeeper.

but i will give it a try.

thanks

1480
Views
0
Helpful
4
Replies