Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DIAL PLAN PROBLEM

Hello All,

I am trying to dial out from my VOIP phone using my PSTN at home. I am able to route calls in to the VOIP phone with no problem after entering "connection plar 5003" Command. When I attempt to use the commands below I get a busy signal. I think my CME is not recognizing the dial plan I configured.

dial-peer voice 1 pots

destination-pattern [770]..[...]....

port 1/0/0

I have tried

destination-pattern 9[770]..[...]....

and

destination-pattern ..........

also what is the right command to dial long distance?

4 REPLIES

Re: DIAL PLAN PROBLEM

A few things to note:

1) on a pots dial peer, any time the digit is explicitly matched, it is dropped.

so pattern 9....

would only send ....

but

pattern (9).... or [19]....

would both send 5 digits.

This is changed with:

forward-digits | all

no digit-strip

changing the destination pattern.

Also:

the [xxx] parameter is an OR operation. What your current destination pattern says is:

7 OR 7 OR 0 followed by two numbers, followed by ANY NUMBER or ANY NUMBER or ANY NUMBER followed by 4 more numbers.

You probably want something like this:

9770.......

forward-digits 10

This will send 770 plus 7 digits. If you need to dial one, add a 1 in the pattern and forward-digits to 11.

Alternatively:

9(1770).......

-nick

New Member

Re: DIAL PLAN PROBLEM

Thanks Nick I will let you know i fthis works for me. The CCNA Voice book realy confused me.

New Member

Re: DIAL PLAN PROBLEM

Hello Nick,

I think everything you told me worked. Please pay no attention to that last email I sent. It was all my fault. Thanks Man

Re: DIAL PLAN PROBLEM

Glad I could help :)

-nick

161
Views
0
Helpful
4
Replies