I am currently running a 4006 with CatOS cat4000-k8.8-4-11-GLX at one of my sites.
I guess my main question is, what are the Auto Qos and DSCP capabilities of this switch? As far as I can tell, there is no Auto QoS. But I wanted to check with people that are more in the know than I am.
The switches have limited qos capabilities, however, if you desire to connect the video server to the switch, you will need to upgrade the current code on the switch to support qos per the below link. Also, on the XL ports trust COS by default, if the Video server is connected to an access port (no cos present), then you will need to also configure the ''switchport priority default 4' to assign COS 4 to the video traffic.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...