E&M to channalized E1 circuit - how to connect remote analog voice lines
I have the following configuration: the 4-wire voice lines are installed in one location. The lines are connected to the Voice E&M interfaces on a 3700 Cisco router. In the other location (2000 miles away, connected by the WAN - T1 line) I have a Hoot and Holler system equipped with an E1 G.703 interface. Is it possible to establish the voice connection between those 2 locations? What hardware I would need to connect the H&H system. Currently I have in both locations just E&M interfaces and I am connecting current H&H system using analog line (4wire) interfaces.
I will really appreciate any help (hints how to solve my problem).
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?