Thanks for your reply. Currently, my customer has an existing VOIP network. They have around 22 different sites and connected via leased lines. In the main sites, they have 2 3660 routers and the 22 remote sites are distributed to these routers accordingly for load balancing. The routing protocol they are using is OSPF.
Since they requirements are increasing they decided to expands and upgrade the existing 3660 routers to 7609 router, while the existing leased lines will upgrdae to E1 links, some of the sites with low requirements will use the same links and those sites with higher demands will upgrade to E1, but the customer are insisting to keep the existing leased lines as backup and the new E1 links as the active.
IntroductionPre-requisite: Caveat :When IPXE Boot could be done : IPXE Boot :Ipxe boot using DHCP Server :
iPXE boot in ASR9K
Migration recommendation document for Cxr to Exr.
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...
Hi community,I just wanted to share my findings about accesing to ACL counters by SNMP on ASR9000/XR.
Searching on Internet I found the section ACL Counters Using SNMP in the IP Addresses and Services Configuration Guide but I didn't found any inf...