Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

en bloc

hi I have a question relating to a problem I am having.If a pbx does not support en bloc (ie pushing the number accross in one go) but only putting out digits one digit at a time (overap) how can I get the router to see this?I have a connection with a mitel pbx and a 3600 using qsig.I am having to get the pbx to forward out a speed dial as such to get the call to work and I think it is effecting other functionalities.thanks

1 REPLY
Silver

Re: en bloc

Configure the D channel to accept overlap receiving using the command :

isdn overlap-receiving

The PBX will then send each digit as a seperate IE and once enough have come in to match on a dial peer the call will proceed.

211
Views
0
Helpful
1
Replies
CreatePlease login to create content