Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

failover from cisco 5400 to ser when busy

I have a AS5400 as our local SIP gateway with 6T1, I would like set up sip client to fail over to another SER proxy that can route to local PSTN when AS5400 capacity is full. Can the AS5400 return special error code or sip signal to sip client?

1 REPLY
Hall of Fame Super Gold

Re: failover from cisco 5400 to ser when busy

You can setup a voip dp with higher preference for the other proxy. Once the trunk-group with the T1s is full, further calls will be sent there.

150
Views
0
Helpful
1
Replies
CreatePlease to create content