Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Fax failure in hairpinned configuration

We have a PGW call-controlled setup for voice. Most of the bearer channels terminate on AS5850's. Clients connected through PRI's are experiencing intermitant Fax problems. Some destinations fail, others send only a header and still others are successful but the image is garbled.

Since most of the calls are hairpinned on the AS5850, I don't know what exactly is causing this problems. Voice calls are successful.

Any ideas on how and where to look for the problem? I have run out of ideas.

4 REPLIES
New Member

Re: Fax failure in hairpinned configuration

Hi!

Did you check for slips on bearer channels?

Ivan

New Member

Re: Fax failure in hairpinned configuration

Yes actually there is SLIP on the channels.

AFAIK SLIP is caused by synchronization problems.

Any other causes? Faulty cabling ?

New Member

Re: Fax failure in hairpinned configuration

another question. The SLIPs that I see are only on one side. I see SLIP on the controller of the SLT that does drop&insert for the bearer channels.

On the AS5850 side I don't see any SLIPs.

Is this normal for SLIP?

New Member

Re: Fax failure in hairpinned configuration

Hi!

There should no slips on the whole path of your voice/fax. Please look at http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a008014f8a6.shtml how to set a proper clock synchronization.

Regards,

Ivan

122
Views
0
Helpful
4
Replies
CreatePlease login to create content