01-26-2009 08:48 AM
I have a UC520 system with a PRI. How do I get a fax machine connected and configured to support inbound and outbound faxes?
The PRI has 100 DIDs and '99' is going to be used for the fax. The fax is plugged into FXS port '0'.
Solved! Go to Solution.
01-26-2009 10:26 AM
voice service voip
modem passthrough nse codec g711u
dial-peer voice 1 pots
port 0
destination-pattern 99
That's about it. You will need to adjust your 'port' command to which 'voice-port' it corresponds to, like 1/0, 0/0/0, etc.
Make sure 'show controllers t1' doesn't have any slips/errored seconds.
hth,
nick
01-26-2009 10:26 AM
voice service voip
modem passthrough nse codec g711u
dial-peer voice 1 pots
port 0
destination-pattern 99
That's about it. You will need to adjust your 'port' command to which 'voice-port' it corresponds to, like 1/0, 0/0/0, etc.
Make sure 'show controllers t1' doesn't have any slips/errored seconds.
hth,
nick
01-29-2009 11:02 AM
That helps quite a lot.
Thanks,
Jeff
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: