Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Fax T38 Over IP : Is it related to Software MTP CUCM

I have implemented VOIP and CUCM for enterprise solution.

My setup is like this:-

Fax1>>CCM5.0>>IPIPGW(transcoder)>>SSW>>Gateway>>PSTN>>Fax2

What is the possibility of FAX T38 not going through even the call signaling & setup have been established and fax tone heard, but there are no response from remote fax.

Is it related to CCM5.0 MTP? As I have this "MTP" check at the SIP trunk to the SSW for sending SIP early-offer.

4 REPLIES
Silver

Re: Fax T38 Over IP : Is it related to Software MTP CUCM

Could you provide the details of these debugs

debug h225 asn1

debug h245 asn1

debug vtsp all

debug voip ccapi inout

debug cch323 all

New Member

Re: Fax T38 Over IP : Is it related to Software MTP CUCM

My apologize.. the CCM actually is connecting ti the IPIPGW.. it is connected to the SSW>> PSTN GW>>> FAX 2.

Attached is the log captured from the CCM..

Fax called from 13324220 to 0060380243462.

I got request time-out error and "request pending error" from the SSW.

Is it related to Carrier/Provider problem or MTP itself?

New Member

Re: Fax T38 Over IP : Is it related to Software MTP CUCM

What faxserver product are you using and what is the topology

GW---SIP---CUCM5.X---SIP---FAXSERVER?

Regards,

Marco

New Member

Re: Fax T38 Over IP : Is it related to Software MTP CUCM

We are not using any fax server. We did fax call to the PSTN fax. Actually, what is the purpose of fax server?

527
Views
0
Helpful
4
Replies