Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

force device out dial-peer

Hello All,

We have (2) SIP trunks, one for long-distance and one for local calls. Our LD provider does not support faxing so i must force fax traffic to our local SIP trunk. I tried using answer-address and preference but it didn't work. Fax machines are connected to ATA boxes. Relevant config is below, please advise.

ephone-dn  32  dual-line

number 2032

description FAX 2032

name FAX 2032

!

ephone  32

device-security-mode none

mac-address 0019.E8AE.8702

max-calls-per-button 2

type ata

button  1:32

!

dial-peer voice 1000 voip

description LD_OUTBOUND

translation-profile incoming 2

translation-profile outgoing 1

destination-pattern ..........

session protocol sipv2

session target ipv4:LD_SIP

  incoming called-number .T

voice-class codec 1 

dtmf-relay rtp-nte

no vad

!

dial-peer voice 995 voip

description LOCAL_OUTBOUND

translation-profile outgoing 4

answer-address 2032

session protocol sipv2

session target dns:LOCAL_SIP

voice-class codec 1 

dtmf-relay rtp-nte

no vad

Thanks in advance.

2 REPLIES

force device out dial-peer

Add the output of the command

debug voip dialpeer all.

Try to remove destination-pattern to dial-peer 1000.

Regards.

Bronze

Re: force device out dial-peer

You van use cor-lists to prevent the fax dn to see the LD dial peer.

So, have a look at cor-lists on CCO.

Regards,

Erik

Sent from Cisco Technical Support iPad App

687
Views
0
Helpful
2
Replies