Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FRF.12 LFI

I'm attempted to configure FRF.12 on my frame-relay links and once I get it configured on both ends, non-tagged traffic comes to a halt. However, traffic that is tagged (RTP, Call Control) passes w/o a hitch.

Currently the frame network passes from the access loop at one of my sites up to the service providers frame switch and then down to my host sites access loop.

Any thoughts?

1 REPLY
New Member

Re: FRF.12 LFI

Just in case anyone runs across this...the reason FRF.12 (or LFI) was not working correctly in my case...one of my sites had two T1's bundled together using FRF.16 (or Multilink Frame-Relay)

Turns out that FRF.16 and FRF.12 are not supported on the same Cisco device. The Dev team expects to have this available late '04 early 05.

190
Views
0
Helpful
1
Replies
CreatePlease to create content