FXO incoming call diverted to "always off-hook" FXO/FXS/E&M port
I am trying to find out if its possible to divert an incoming PSTN call through an FXO (origination) port to a FXO/FXS/E&M (destination) port (on the same router) which is always open or off-hook . The incoming call can be automatically answered without picking up the phone handset (which is connected to the destination FXO/FXS/E&M port).
Something like this -
PSTN ---> FXO ---> FXO/FXS/E&M (always off-hook) ---> phone set
I have tried the config below but it requires someone to answer (off-hook) the phone when it rings.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...