Getting Busy Signal when calling Voice Mail System
We currently have a CME 8.0/CUE 7.1
The system currently has a four-port FXO card. I am able to call outside phone numbers as well as inbound. I can call between internal extensions. When I try to access voicemail, I receive a busy signal. It was working and now it is not. I have checked the IP addresses as well as the dial-peers and they are correct. I am also able to access the CUE GUI without a problem.
I am new to this and trying to learn it all as my company has not sent me to training. This is in my lab environment.
Re: Getting Busy Signal when calling Voice Mail System
Do a "debug voip dialpeer" while making the call to see what outbound dialpeer is matched. It should be the one you have configured for CUE. If it is correct, make sure the correct codec is being used. You may want to post a config too so we can be more helpful.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...