In advance to reduce the time that a call is closed after the called hangup i need to instruct my gateways to close the call when isdn NOTIFY message is received. What is the settings needed to do this ?
I see in debugs that the pstn isdn switch send a NOTIFY message when the called subscriber hangup, 60 seconds later i receive the DISCONNECT message from switch.
In TCLHandler the event of NOTIFY is received as EV_CALL_SUSPEND_ACK but i cannot handle this with:
set fsm(CALLACTIVE,ev_suspend_ack) "act_Cleanup,CALLDISCONNECT"
Were you able to resolve the above issue, as we are currently running into the same.
Whenever the called party hang's up we get the disconnect message after 30 secs.
Is there a solution to this problem, as generally here in the US its a FCC regulation so CO dont send Disconnect whenever the called party hangs up, instead they recv a SS7 suspend which invokes a suspend timer on the orig Switch and finally when the timer expires the call tear down happens.
We have spoken to the carrier, if they can send us a Q931 notify, or suspend so that we can act upon it.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...