Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Help configuring VIC-4FXO-M1 on MRP300

I've had a VIC-4FXO-M1 in my MRP300 for years and am finally getting around to needing it. I've upgraded the IOS to 123-7.XR6, but the IOS is not recognizing the FXO ports when I do "show version". No "voice-port" entries appear in the IOS config. When I type "show diag", the VIC is shown so I don't understand why I don't get "voice-port" entries in IOS. Please help! My only guess, based on scattered doc I've found, is that perhaps I need to purchase a PVDM-4 before I can get this working.

"show diag" output:

Packet Voice DSP Module Slot 0:

Not populated

Packet Voice DSP Module Slot 1:

Not populated

WIC Slot 0:

Four port FXO-North America/M1 Voice Interface Card

Daughter card-Version 4 TLV Cookie Format

Hardware Revision : 4.0

Part Number : 73-7119-04

Board Revision : A0

Deviation Number : 0-0

Fab Version : 03

PCB Serial Number : JAD06520SG1

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Top Assy. Part Number : 800-17617-02

Connector Type : 01

Product (FRU) Number :

1 REPLY
Silver

Re: Help configuring VIC-4FXO-M1 on MRP300

You have answered your own question - you need a DSP module to process the voice calls.

The PVDM-4 would only handle 2 ports, so you actually require a PVDM-8 (or 2 PVDM-4 modules) to support the 4 FXO ports.

119
Views
0
Helpful
1
Replies
CreatePlease to create content