Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do you verify how many dsp resources are being used?

I have a 28xx IOS router with 8 fxo's and 2 x 16 channel pvdm2's.  I want to use dsp resources for hardware MTP but when I try to configure it I only have 0 as an allowed entry.

(config-dspfarm-profile)#maximum sessions hardware ?
  <0-0>  Number of sessions assigned to this profile

I thought I would have at least 16 available to assign.    Any advice?

2 REPLIES

Re: How do you verify how many dsp resources are being used?

Do a "show voice dsp" to see where the DSP resources are allocated. Also, be sure you have DSP service enabled for the voice card such as:

voice-card 1

dsp services dspfarm

Hope this helps.

Brandon

Re: How do you verify how many dsp resources are being used?

You can also try this command:

show call resource voice stats

And you have 0 as it was mentioned in the answer above: "dsp services dspfarm" command was not entered under

voice-card 1

4172
Views
0
Helpful
2
Replies