If by PT you mean point codes, then you can have six OPCs by default, and I'm not sure what the limit is on DPCs, but I have seen many more than ten. If you need more than six OPCs there are some ways to accomplish this.
I configured one for a client with five as5400s hooked to four switches with bearer and data links all over the place. Very versatile and redundant, but rather a headache.
as5400 is fine, but there are some limits on the number of F/A (data) links you can have if you are going to need a separate F link for each switch. Again, there are ways to work around it, but 'it depends'.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...