I have a 2921 and is activated on the Lan, then I added the router to Call Manger from Device/Gateway/Add New/2921/MGCP/Domain Name/Module in Slot 0 ( NM-4WIC-MBRD ), then I activateda E1 to ( 0/0/0 ). How I can add the Gatway ( port -0/0/0 ) to a Route Group and what commands I have to do from the 2921 to be visible on the Call Manger.
On the Route Group/Find Device to Add to Route Group/ Device Name contains I don't see the ports from my 2921.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...