Re: How to configure AS5400 for signaling mode with PGW2200
The Cisco PGW 2200 is designed to provide maximum support for different IP network architectures. This flexibility helps enable the Cisco PGW 2200 to provide an SS7 interconnect for H.323- or SIP-based networks where the call control resides in the Cisco AS5000 Voice Gateways (signaling mode), or it can provide intelligent call control and routing functions for MGCP-based voice gateways (call control mode) while concurrently providing an H.323 or SIP interface for maximum flexibility and interoperability.
The following PSTN gateway applications are enabled by the Cisco PGW 2200:
Voice-over-IP (VoIP) transit
Primary Rate Interface (PRI) Grooming and Time-Division Multiplexing (TDM) Offload
SIP PSTN gateway
H.323 PSTN gateway
Enterprise Services (Hosted Voice and Call Center)
Question: Have the phone connected and can ring out-but no sound coming from the handset - analog home phone - phone makes connection and pick up at the other end is ok. Can you help?
Question: Have the phone connected and can ring out-but no sound coming from the handset - analog home phone - phone makes connection and pick up at the other end is ok. Can you help?Answer
iPXE boot in ASR9K
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...