Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

how to debug "vic-2fxo"'s dialer information?

who can tell the correct way to see the debug information about the vic-2fxo?

once i have used the command" debug dialer events" and " debug dialer packets" in the router. And I can initiate a successful call from remote phone to the Call manger through the vic-2fxo in the router. But I can see any debug information in the router either at the console or at the remote terminal.

Thanks

Sincerely

4 REPLIES
New Member

Re: how to debug "vic-2fxo"'s dialer information?

What debug information are you looking for. If you are using FXO for voip purposes then debug vpm would show you the voice port signaling events and debug vtsp all would show you debug of vtsp layer when it communicates with the ccapi layer. For voip you can turn on debug voip ccapi inout. There are other deugs that can give you much more verbose information if you want to read through the h225 and h245 messages.

New Member

Re: how to debug "vic-2fxo"'s dialer information?

Thanks for your help. one more question: how to see the original call number in the router through debug command?

Sincerely

New Member

Re: how to debug "vic-2fxo"'s dialer information?

You would need the fxo-m1 card to support the caller id. The debug voip ccapi inout should tell you called party number as well calling party number.

New Member

Re: how to debug "vic-2fxo"'s dialer information?

Thank you very much. Now I can offer the reason to the client. :)

Sincerely

229
Views
0
Helpful
4
Replies
CreatePlease to create content