is it possible to simulate a PSTN with tree routers (e.g. 2x 1841, 2821)? Each is equipped with an CTRLR E1 Module (VWIC2-2MFT-G703). Both routers are conntect with an special cross cable to get the interface active.
!!! This should become a test envoirement !!!
Now I would like to connect a CUCM to the first 1841 an a second CUCM to the other 1841. The test setup should look like this:
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...