Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

If possible ,Could you please tell me correct config ?

Hi Expert,

I need to ask for your advice.

Please look at the the following diagram.

Phone No.900 [AnalogPhone1]--[FXS]-[VGW1]-[E&M]===cable===[E&M]-[VGW2]-[FXS]--[AnalogPhone2] Phone No.100

I would like to make telephone call  from [AnalogPhone1] to [AnalogPhone2].

I did set the following.

---------------------------------------------------------------------------------------------------------------

VGW1:

!

voice-port 0/0/0

ring frequency 50

timing hookflash-in 500 150

description *** FXS ***

!

voice-port 0/1/0

operation 4-wire

type 5

cptone JP

timeouts interdigit 4

timing dialout-delay 180

description *** E&M ***

!

dial-peer voice 1 pots

description *** Analog Phone1 ***

destination-pattern 900

port 0/0/0

!

dial-peer voice 100 pots

description *** to E&M Port 0/1/0 ***

destination-pattern 1..

port 0/1/0

prefix 100

-----------------------------------------------------------------------------------------------------

VGW2:

!

voice-port 0/0/0

operation 4-wire

type 5

cptone JP

timeouts interdigit 4

timing dialout-delay 180

description *** E&M ***

!

voice-port 0/1/0

ring frequency 50

cptone JP

timing hookflash-in 500 150

description *** FXS ***

!

dial-peer voice 1 pots

destination-pattern 100

port 0/1/0

!

dial-peer voice 2 pots

description *** to E&M Port 0/0/0 ***

destination-pattern 9..

port 0/0/0

prefix 9

!

--------------------------------------------------------------------------------------------------------------

But, could not telephone between Analog Phone1 and  Analog Phone 2.

Maybe I think that It's easy miss config.

If possible ,Could you please tell me correct config ?

Thanks,

Best regards,

Takuro

Everyone's tags (2)
1 REPLY
New Member

If possible ,Could you please tell me correct config ?

Hi Expert,

sorry.

I just solved now.

I changed operation 4-wire to operation 2-wire.

Thanks,

Best regards,

Takuro

1206
Views
0
Helpful
1
Replies