Hi Expert,
I need to ask for your advice.
Please look at the the following diagram.
Phone No.900 [AnalogPhone1]--[FXS]-[VGW1]-[E&M]===cable===[E&M]-[VGW2]-[FXS]--[AnalogPhone2] Phone No.100
I would like to make telephone call from [AnalogPhone1] to [AnalogPhone2].
I did set the following.
---------------------------------------------------------------------------------------------------------------
VGW1:
!
voice-port 0/0/0
ring frequency 50
timing hookflash-in 500 150
description *** FXS ***
!
voice-port 0/1/0
operation 4-wire
type 5
cptone JP
timeouts interdigit 4
timing dialout-delay 180
description *** E&M ***
!
dial-peer voice 1 pots
description *** Analog Phone1 ***
destination-pattern 900
port 0/0/0
!
dial-peer voice 100 pots
description *** to E&M Port 0/1/0 ***
destination-pattern 1..
port 0/1/0
prefix 100
-----------------------------------------------------------------------------------------------------
VGW2:
!
voice-port 0/0/0
operation 4-wire
type 5
cptone JP
timeouts interdigit 4
timing dialout-delay 180
description *** E&M ***
!
voice-port 0/1/0
ring frequency 50
cptone JP
timing hookflash-in 500 150
description *** FXS ***
!
dial-peer voice 1 pots
destination-pattern 100
port 0/1/0
!
dial-peer voice 2 pots
description *** to E&M Port 0/0/0 ***
destination-pattern 9..
port 0/0/0
prefix 9
!
--------------------------------------------------------------------------------------------------------------
But, could not telephone between Analog Phone1 and Analog Phone 2.
Maybe I think that It's easy miss config.
If possible ,Could you please tell me correct config ?
Thanks,
Best regards,
Takuro
