Incoming Modem call through CallManager based VoIP?
Is there a way to take a modem call on a CallManager based VoIP system? I have a T1 coming into a 6608 blade in a 6000 series switch. This blade is the gateway for my callmanager to the pstn. I'm wondering if there is a way to for the system to route a given DN to an FXO port that would have a modem attached. Currently all of my RAS lines are routed through our legacy pbx which drastically degrades the dial-in speeds.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...