I want to connect the E1 coming out of an Alcatel 1000 S12 Switch into the Cisco AS5350. The Alcatel Switch has SS7 and V5.2 as the standard interfaces. The E1 is a Tx and Rx pair with BNC type terminators. Can anyone suggest me how I can achive this??
IntroductionPre-requisite: Caveat :When IPXE Boot could be done : IPXE Boot :Ipxe boot using DHCP Server :
iPXE boot in ASR9K
Migration recommendation document for Cxr to Exr.
This document applies to NCS5500 and ASR9000 routers and has been verified as such.
traditional ECMP or equal cost multipath loadbalances traffic over a number of available paths towards a destination. When one path fails, the traffic gets r...
Hi community,I just wanted to share my findings about accesing to ACL counters by SNMP on ASR9000/XR.
Searching on Internet I found the section ACL Counters Using SNMP in the IP Addresses and Services Configuration Guide but I didn't found any inf...