I'm running v.2.1 for the ip communicator. Every since I upgraded from 2.02 I have had a lot of complaints from users stating that they can't dial 800#. all other numbers work. If I un-check the "Optimize for Low Bandwidth" it works. user are able to dial toll free numbers. the problem is this can only be a temporary fix. I need a more permanent fix. Can any give me any insight on this?
You will get a message like that you're call cannot be completed as dialed, please hang up and try again.Doesn't look like you have a pattern for dialing 411. When dialing 800 numbers are you dialing a leading 91 to hit the 9.@ Route Pattern?
Probably will need to see detailed CCM traces from the CallManagers that the test phone and the MGCP GW is registered to. This will give an idea of what is happening.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...